Avago Technologies MegaRAID Fast Path Software - Manual (Page 288)

Page 288 LSI Corporation Confidential | July 2011
MegaRAID SAS Software User Guide Chapter 6: MegaRAID Storage Manager Overview and Installation | Installing MegaRAID Storage Manager
The -ru popup command removes the pop-up from the installation list.
You also can run a non-interactive installation using the RunRPM.sh command.
The installer offers the following setup options:
 Complete – This installs all the features of the product.
 Client Components Only – The storelib feature of the product is not installed in
this type of installation. As a result, the resident system can only administer and
configure all of the servers in the subnet, but it cannot serve as a server.
 StandAlone – Only the networking feature will not be installed in this case. But the
system can discover other servers in the subnet and can be discovered by the other
servers in the subnet.
 Local - This option enables you to view only the workstation that has the MegaRAID
Storage Manager software installed. You will not be able to discover other remote
servers and other remote servers will also not be able to connect to your
workstation. In a local mode installation, you will be using the loopback address
instead of the IP address.
This installation helps you select any of the setup types, but if you run RunRPM.sh, it
installs the complete feature.
6.4.6 Prerequisites for Installing
MegaRAID Storage Manager on the
RHEL6.0 x64 Operating System
Before installing the MegaRAID Storage Manager software on RHEL 6.0 x64 system,
install the following RPMs. Without these RPMs the MegaRAID Storage Manager
software might not install properly or might not work as expected.
 libstdc++-4.4.4-13.el6.i686.rpm
 compat-libstdc++-33-3.2.3-69.i686.rpm
 libXau-1.0.5-1.el6.i686.rpm
 libxcb-1.5-1.el6.i686.rpm
 libX11-1.3-2.el6.i686.rpm
 libXext-1.1-3.el6.i686.rpm
 libXi-1.3-3.el6.i686.rpm
 libXtst-1.0.99.2-3.el6.i686.rpm
The RHEL6.0 RC1 complete operating system installation is required for the MegaRAID
Storage Manager software to work. The above mentioned rpm's come as part of RHEL6
RC1 Operating System DVD. These RPMs might need additional dependent RPMs as
well, and you must also install all of the dependent RPMs on the target system.
6.4.7 Linux Error Messages The following messages can appear while you are installing the MegaRAID Storage
Manager software on a Linux operating system:
 More than one copy of MegaRAID Storage Manager software
has been installed.
This message indicates that the user has installed more than one copy of the
MegaRAID Storage Manager software. (This step can be done by using the
rpm-force
command to install the rpm file directly, which is not recommended,
instead of using the install.sh file.) In such cases, the user must uninstall all of
the rpm files manually before installing the MegaRAID Storage Manager software
with the procedure listed previously.