Avago Technologies MegaRAID Fast Path Software - Manual (Page 301)

LSI Corporation Confidential | July 2011 Page 301
MegaRAID SAS Software User Guide Chapter 6: MegaRAID Storage Manager Overview and Installation | Installing and Configuring an SNMP Agent
2. Select Add/Remove Windows Components in the left side of the Add/Remove
Programs window.
3. Select Management and Monitoring Tools.
4. Click Next, and follow any prompts to complete the installation procedure.
6.7.5.3 Configuring SNMP
Service on the Server Side
Perform the following steps to configure SNMP Service on the server side.
1. Select Administrative Tools from the Control Panel.
2. Select Services in the Administrative Tools window.
3. Select SNMP Service in the Services window.
4. Open SNMP Service.
5. Click the Security tab, and make sure that Accept SNMP Packets from any host is
selected.
6. Click the Traps tab, and select the list of host IP addresses to which you want the
traps to be sent with the community name.
6.7.5.4 Installing SNMP Service
for the Windows 2008 Operating
System
Before you install the LSI Agent, make sure that SNMP Service is already installed in the
system.
If you do not have SNMP Service installed on your system, perform the following steps
to install SNMP Service for Windows 2008 system.
1. Select Program and Features from the Control Panel.
2. Click Turn windows feature on/off to select the windows components to install.
3. Select Features from the menu.
4. Click Add Features.
5. Select SNMP Services.
6. Click Next.
7. Click Install, and the SNMP installation starts. You will be prompted for the
Windows 2008 CD during the installation.
8. Insert the CD, and click Ok. The installation resumes.
After the installation is finished, the system displays a message saying that the
installation is successful.
6.7.5.5 Configuring SNMP
Service on the Server Side for the
Windows 2008 Operating System
To configure SNMP service on the server side for Windows 2008 operating system,
perform the following steps:
1. Select Administrative Tools from the Control Panel.
2. Select Services from Administrative Tools window.
3. Select SNMP Service from the Services window.
4. Open SNMP Service, and go to its properties.
5. Go to the Security tab, and make sure that Accept SNMP Packets from any host is
selected.
6. Click the Traps tab, and select the list of host IP addresses to which you want the
traps to be sent with the community name.