Avago Technologies MegaRAID Fast Path Software - Manual (Page 235)

LSI Corporation Confidential | July 2011 Page 235
MegaRAID SAS Software User Guide Chapter 5: MegaRAID Command Tool | Controller Property-Related Options
5.8.9 Set Time and Date on
Controller
Use the command in the following table to set the time and date on the selected
controllers.
5.8.10 Display Time and Date on
Controller
Use the command in the following table to display the time and date on the selected
controllers.
5.8.11 Get Connector Mode Use the command in the following table to display which ports are enabled
(Internal/External, 0/1) on the MegaRAID SAS 8888ELP RAID controller.
NOTE: This command is reserved strictly for the SAS 8888ELP RAID controller at this
time. You must enable specific ports depending on how you intend to use the controller.
5.8.12 Set Connector Mode Use the command in the following table to set (enable) the connectors for the
MegaRAID SAS 8888ELP RAID connectors that are listed in
Section 5.8.11, Get
Connector Mode .
Table 55: Set Time and Date on Controller
Convention MegaCli –AdpSetTime yyyymmdd HH:mm:ss
-aN|-a0,1,2|-aALL
Description Sets the time and date on the controller. This command uses a 24-hour
format.
For example, 7 p.m. displays as 19:00:00. The order of date and time is
reversible.
Table 56: Display Time and Date on Controller
Convention MegaCli –AdpGetTime -aN
Description Displays the time and date on the controller. This command uses a 24-hour
format. For example, 7 p.m. would display as 19:00:00.
Table 57: Get Connector Mode
Convention MegaCli -AdpGetConnectorMode
-ConnectorN|-Connector0,1|-ConnectorAll
-aN|-a0,1,2|-aALL
Description Displays which ports are enabled (Internal/External, 0/1).
For example, if internal port 0 is active, internal ports 0–3 are active. If
external port 1 is active, external ports 4–7 are active.