Avago Technologies MegaRAID Fast Path Software - Manual (Page 307)

LSI Corporation Confidential | July 2011 Page 307
MegaRAID SAS Software User Guide Chapter 7: MegaRAID Storage Manager Window and Menus | Starting the MegaRAID Storage Manager Software
If you click Configure Host, the configure host opens, as shown in the following
figure.
Figure 172: Configure Host
The following options are available to configure the host.
 Display only the local server – Select this option to display only the Local server or
the Server of the IP address entered in the Host View screen.
 Display the systems from the following favorite list – You can enter the IP Addresses
of the servers of choice to discover. It will discover only those servers.
 Display all the systems in the Network of the local server – Select this option to
allow MegaRAID Storage Manager server to start the discovery process of all the
available remote servers (including the VMware ESXi server) in the subnet
mentioned MegaRAID Storage Manager server in the host view screen.
After selecting the configure host option click on Save Settings to save your setting, or
on Cancel to quit without saving.
Select the Stop discovery process of remote servers check box and click on Save
Settings, to abort the discovery process which has already begun. This check box is
enabled only when there is a active discovery process.
The discovery process might take very long time to complete, you can use this function
to abort this process.
NOTE: For the VMware ESXi, the server icon does not denote the health of the server.
The icon is always green regardless of the health of the system.