Avago Technologies MegaRAID Fast Path Software - Manual (Page 384)

Page 384 LSI Corporation Confidential | July 2011
MegaRAID SAS Software User Guide Chapter 9: Monitoring Controllers and Its Attached Devices | Removing Email Addresses of Recipients of Alert Notifications
9.11 Removing Email
Addresses of Recipients of Alert
Notifications
Use the Email tab in the Configure Alerts window to remove email addresses of the
recipients of alert notifications.
1. Click the Email tab on the Configure Alerts window.
The Email section of the window appears, as shown in the previous figure.
2. Click an email address in the Recipient email addresses field.
The Remove button, which was grayed out, is now active.
3. Click Remove. The email address is deleted from the list.
9.12 Saving Backup
Configurations
You can save an .xml backup file of the entire alert configuration. This includes all the
settings on the three tabs (Alert Settings, Mail Server, and Email).
1. On the Configure Alerts window, click the Alert Setting tab, Mail Server tab, or
the Email tab.
2. Click Save Backup. The drive directory appears.
3. Enter a filename with an .xml extension for the backup configuration (in the format
filename.xml ).
4. Click Save. The drive directory disappears.
5. Click OK. The backup configuration is saved and the Configure Alerts window
closes.
9.13 Loading Backup
Configurations
You can load all of the values from a previously saved backup into the Configure Alert
window (all tabs) to edit or save these values as the current alert notification
configuration.
NOTE: If you choose to load a backup configuration and the Configure Alerts window
currently contains changes that have not yet been saved as the current alert notification
configuration, the changes will be lost. You are prompted to confirm your choice.
1. On the Configure Alerts window, click the Alert Setting tab, Mail Server tab, or
Email tab.
2. Click Load Backup.
You are prompted to confirm your choice. The drive directory appears from which
you can select a backup configuration to load.
3. Select the backup configuration file (it should be in .xml format).
4. Click Open. The drive directory disappears.
5. Click OK. The backup configuration is saved and the Configure Alerts window
closes.