Avago Technologies MegaRAID Fast Path Software - Manual (Page 234)

Page 234 LSI Corporation Confidential | July 2011
MegaRAID SAS Software User Guide Chapter 5: MegaRAID Command Tool | Controller Property-Related Options
5.8.6 Display Specified Controller
Properties
Use the command in the following table to display specified properties on the selected
controllers.
NOTE: The tty log can be saved at the controller level.
5.8.7 Set Factory Defaults Use the command in the following table to set the factory defaults on the selected
controllers.
5.8.8 Set SAS Address Use the command in the following table to set the SAS address on the selected
controllers.
Table 52: Display Specified Controller Properties
Convention MegaCli –AdpGetProp CacheFlushInterval | RebuildRate | PatrolReadRate| BgiRate |
CCRate | ReconRate | SpinupDriveCount | SpinupDelay | CoercionMode |
PredFailPollInterval | ClusterEnable | BatWarnDsbl | EccBucketSize | EccBucketLeakRate
| EccBucketCount | AlarmDsply | AbortCCOnError | AutoDetectBackPlaneDsbl |
CopyBackDsbl | LoadBalanceMode | SMARTCpyBkEnbl | SSDSMARTCpyBkEnbl |
MaintainPdFailHistoryEnbl | EnblSpinDownUnConfigDrvs | EnblSSDPatrolRead | NCQDsply |
UseFDEOnlyEncrypt | WBSupport | AutoEnhancedImportDsbl | PrCorrectUncfgdAreas |
DsblSpinDownUnConfigDrvs | ENABLEEGHSP | ENABLEEUG | ENABLEESMARTER -aN|-a0,1,2|-aALL
Description Displays the properties on the selected controllers.
EccBucketCount : Count of single-bit ECC errors currently in the bucket.
WBSupport : Enables support for the Write Back option as the Write Policy.
DsblSpinDownUnConfigDrvs : Disable spindown of unconfigured drives.
ENABLEEGHSP : Enable global hot spare is three bits or adapter level for setting hot spare properties.
Values: 0= Disable and 1: Enable.
ENABLEEUG : Enable unconfigured good for emergency is three bits or adapter level for setting hot spare properties.
Values: 0= Disable and 1: Enable
ENABLEESMARTER : Emergency for SMARTer is three bits or adapter level for setting hot spare properties.
Values: 0= Disable and 1: Enable
See Table 51 for explanations of the other options.
Table 53: Set Factory Defaults
Convention MegaCli -AdpFacDefSet -aN|-a0,1,2|-aALL
Description Sets the factory defaults on the selected controllers.
Table 54: Set SAS Address on Controller
Convention MegaCli –AdpSetSASA str[0-64] -aN
Description Sets the controller’s SAS address. This string must be a 64-digit hexadecimal
number.