Avago Technologies MegaRAID Fast Path Software - Manual (Page 299)

LSI Corporation Confidential | July 2011 Page 299
MegaRAID SAS Software User Guide Chapter 6: MegaRAID Storage Manager Overview and Installation | Installing and Configuring an SNMP Agent
The following commands are used to start, stop, restart, and check the status of the SAS
SNMP Agent daemon:
 Start: #/etc/init.d/lsi_mrdsnmpd start
 Stop: #/etc/init.d/lsi_mrdsnmpd stop
 Restart: #/etc/init.d/lsi_mrdsnmpd restart
 Status: #/etc/init.d/lsi_mrdsnmpd status
6.7.4.5 Configuring the
snmpd.conf File
By default, you can run the SNMP queries (walk, get) from any remote machine without
any changes to the snmpd.conf file. To quickly add a new community and client
access, perform the following steps:
1. Stop the SMA service by running the following command:
# svcadm disable svc:/application/management/sma:default
2. Add read-only and read-write community names.
a. Add a read-only community name and client/hostname/ipaddress under
SECTION: Access Control Setup in the /etc/sma/snmp/snmpd.conf
file, as shown in the following excerpt.
#################################################
# SECTION: Access Control Setup
# This section defines who is allowed to talk to
# your running SNMP Agent.
# rocommunity: a SNMPv1/SNMPv2c read-only access
# community name
# arguments: community
# [default|hostname|network/bits] [oid]
# rocommunity snmpclient 172.28.157.149
#################################################
b. Add a readwrite community name and client, hostname, ipaddress under
SECTION: Access Control Setup in /etc/sma/snmp/snmpd.conf file,
as shown in the following excerpt.
#################################################
# SECTION: Access Control Setup
# This section defines who is allowed to talk to your
# running snmp agent.
# rocommunity: a SNMPv1/SNMPv2c read-only access
# community name
# arguments: community
# [default|hostname|network/bits] [oid]
# rwcommunity snmpclient 172.28.157.149
#################################################
3. Start the SMA service by using the following command:
# svcadm enable svc:/application/management/sma:default
NOTE: Refer to the command man snmpd.conf for more information about
configuring the snmpd.conf file.