Avago Technologies MegaRAID Fast Path Software - Manual (Page 237)

LSI Corporation Confidential | July 2011 Page 237
MegaRAID SAS Software User Guide Chapter 5: MegaRAID Command Tool | BIOS-Related Properties
5.9.2 Set Patrol Read Delay Interval Use the command in the following table on the selected controllers to set the time
between patrol read iterations.
5.10 BIOS-Related Properties You can use the commands in this section to select the settings for BIOS-related
options.
5.10.1 Set or Display Bootable Virtual
Drive ID
Use the command in the following table to set or display the ID of the bootable virtual
drive.
NOTE: This option does not write a boot sector to the virtual drive. The operating
system does not load if the boot sector is incorrect.
5.10.2 Select BIOS Status Options Use the command in the following table to set the options for the BIOS status.
Table 60: Set Patrol Read Delay Interval
Convention MegaCli –AdpPRSetDelay –Val -aN|-a0,1,2|-aALL
Description Sets the time between patrol read iterations on a single controller, multiple
controllers, or all controllers:
-Val : Sets delay time between patrol read iterations. The value is time of
delay in hours. A value of zero means no delay and an immediate restart.
Table 61: Bootable Virtual Drive ID
Convention MegaCli –AdpBootDrive {-Set –Lx| -physdrv[E0:S0]}} |
-Get -aN|-a0,1,2|-aALL
Description Sets or displays the bootable virtual drive ID:
-Set –Lx| -physdrv[E0:S0] : Sets the virtual drive as bootable so
that during the next reboot, the BIOS looks for a boot sector in the specified
virtual drive. Identifies the physical drive in the virtual drive, by enclosure
and slot, to use to boot.
-Get : Displays the bootable virtual drive ID.
Table 62: Options for BIOS Status
Convention MegaCli –AdpBIOS -Enbl|-Dsbl| SOE | BE |
EnblAutoSelectBootLd | DsblAutoSelectBootLd |-Dsply|
-aN|-a0,1,2|-aALL
Description Sets the BIOS options. The following are the settings you can select on a
single controller, multiple controllers, or all controllers:
-Enbl , -Dsbl: Enables or disables the BIOS status on selected controllers.
-SOE : Stops on BIOS errors during POST for selected controllers. When set to
-SOE , the BIOS stops in case of a problem with the configuration. This
setting allows you to enter the configuration utility to resolve the problem.
This setting is available only when you enable the BIOS status.
-BE : Bypasses BIOS errors during the POST. This value is available only when
you enable the BIOS status.
-EnblAutoSelectBootLd | DsblAutoSelectBootLd : Enable or
disable automatic selection of the boot virtual drive.
-Dsply : Displays the BIOS status on selected controllers.