Avago Technologies MegaRAID Fast Path Software - Manual (Page 383)

LSI Corporation Confidential | July 2011 Page 383
MegaRAID SAS Software User Guide Chapter 9: Monitoring Controllers and Its Attached Devices | Adding Email Addresses of Recipients of Alert Notifications
9.9 Adding Email Addresses
of Recipients of Alert
Notifications
The Email tab in the Configure Alerts window shows the email addresses of the
recipients of the alert notifications. The MegaRAID Storage Manager software sends
alert notifications to those email addresses. Use the Configure Alerts window to add or
remove email addresses of recipients and to send test messages to recipients that you
add.
To add email addresses of recipients of the alert notifications, perform the following
steps:
1. Click the E-mail tab in the Configure Alerts window.
Figure 252: Adding Email Settings
2. Enter the email address you want to add in the New recipient email address field.
3. Click Add. The new email address appears in the Recipient email addresses field.
9.10 Testing Email Addresses
of Recipients of Alert
Notifications
Use the Email tab in the Configure Alerts window to send test messages to the email
addresses that you added for the recipients of alert notifications.
1. Click the Email tab on the Configure Alerts window.
The Email section of the window appears, as shown in the above figure.
2. Click an email address in the Recipient email addresses field.
3. Click Test.
4. Confirm whether the test message was sent to the email address.
A pop-up message indicates if the test message sent to the email address was
successful. If the MegaRAID Storage Manager software cannot send an email message
to the email address, an error message appears.