Metrohm tiamo 1.0 Manual - Manual (Page 99)

Manual control 75
Rinse position
If this option is enabled then the current lift position is assigned as the rinse
position of the tower.
Selection:
[ Tower 1 ], Tower 2 (not for 730 Sample Changer),
Tower 1+2 (only for 730 Sample Changer)
Shift position
If this option is enabled then the current lift position is assigned as the shift
position of the tower.
Selection:
[ Tower 1 ], Tower 2 (not for 730 Sample Changer),
Tower 1+2 (only for 730 Sample Changer)
External positions
Special position
If this option is enabled then the current lift position is assigned as the spe-
cial position of the tower.
Selection:
[ Tower 1 ], Tower 2 (not for 730 Sample Changer),
Tower 1+2 (only for 730 Sample Changer)
Swing position
If this option is enabled then the current lift position is assigned as the
swing position of the swing head.
Selection:
[ External positions ]
Trigger the assignment. During the assignment the cursor appears as an
hourglass.
Assign robotic arm position
Assigns the current rack position as a particular robotic arm external posi-
tion.
Current position
Shows the current position of the robotic arm in °.
External position
[ 1 ] ... 4
Selection of the external position to which the current robotic arm position is
to be assigned.
Trigger the assignment. During the assignment the cursor appears as an
hourglass.