Metrohm tiamo 1.0 Manual - Manual (Page 292)

268 Database
Show end points
on, [ off ]
If this option is enabled then the found end points will be indicated on the
curve by the symbol ♦ and labeled with
EP# (potentiometric end points),
BP# (break point) or FP# (fixed end point).
Automatic EPs
Color selection, [ black ]
Selection of the color for automatically set end points.
Manual EPs
Color selection, [ light red ]
Selection of the color for manually set end points.
Show evaluation lines
on, [ off ]
If this option is enabled then the evaluation lines (tangents, auxiliary lines)
will be shown.
Tangents
Color selection, [ green ]
Selection of the color for the tangents and auxiliary lines.
Auxiliary lines
Color selection, [ blue ]
Selection of the color for the auxiliary lines.
Measuring point list
Parameters for showing the measuring point list.
Command type
[ DET ], MET, SET, KFT, KFC, MEAS, MEAS T/Flow
Selection of the command type for which the curve properties are to be de-
fined. The curve properties defined per command type are saved per curve
window and per client.
Note
When the dialog window is opened the particular
Command type that will be se-
lected as standard is that which applies for the curve shown in the curve win-
dow.