Metrohm tiamo 1.0 Manual - Manual (Page 355)

Commands 331
External measured value
With the option Additional measured value 3 new measured values can be taken
over from existing measuring commands (i.e. MEAS ). They can be displayed in
curves with the identification External 1...3 or used as variables 'Command
name.EX1...3' in formulae.
Command
Selection from existing measuring commands
Selection of the command from which the additional measured value will be
taken over.
Quantity
Selection from existing measuring quantities
Selection of the quantity from the command which will be adopted as quan-
tity of the additional external measured value.
Unit
Unit of calculated measured value.
Comment
250 characters, [ 'empty' ]
Comment about the external measured value.
DET U
Command for Dynamic Equivalence Point Titrations with potentiometric volt-
age measurement.
Devices
This command can be executed with the following devices which have the DET
mode:
Titrino: 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836
Appearance
The command has the following appearance:
Parameters
The parameters for the command DET U are configured in the following 7 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.