Metrohm tiamo 1.0 Manual - Manual (Page 500)

476 Method
HEATER - properties
Command name
25 characters, [ Oven temperature # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a 774 Oven Sample Processor from the device table. Addition-
ally,
not defined can be selected. In this case, the device name must be as-
signed by the user at the start of the method.
Device type
774 Oven Sample Processor
Display of the device type. If a device is selected under Device name , this
parameter is not editable any more. The device type belonging to the se-
lected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Heater
Target temperature
50 ... 250 °C, [ init.temp. ], off
Temperature at which the oven has to be heated. With init.temp. the oven
heater will be switched on simultaneously with the 774 Oven Sample Proc-
essor and the oven is heated up to this temperature. The initial temperature
must be defined at the 774 Oven Sample Processor and is only displayed
in the configuration of the 774 Oven Sample Processor.
Note
It is advisable to define an initial temperature if you work always at the same
temperature.
Heating time
1 ... 999 min, [ off ]
The target temperature has to be reached within this time. The heating rate
can be modified with the heating time in order to program temperature
ramps or entire temperature profiles (with several
HEATER commands). off