Metrohm tiamo 1.0 Manual - Manual (Page 45)

Formula editor 21
Identifier Description Commands
.LCO Loop counter = current number of completed loops both for
Repeat and While loops
LOOP, CAL LOOP
.LP.CA# Calculated value # (1...3) for the last measuring point DET, MET, SET,
KFT, KFC ,MEAS
.LP.CHA Charge for last measuring point in mA·s KFC
.LP.DME Difference in measured values for last measuring point MET
.LP.DVT dV/dt for the last measuring point (SET) or drift for last measuring
point in µg/min (KFC) SET, KFC
.LP.ERC ERC for last measuring point DET
.LP.EX# External value # (1...3) for last measuring point DET, MET, SET,
KFT, KFC, MEAS
.LP.GFL Gas flow value for last measuring point in mL/min MEAS T/Flow
.LP.IGE Current pulse current for last measuring point in mA KFC
.LP.QTY Measured value (water) for last measuring point in µg KFC
.LP.TEM Temperature for last measuring point in °C DET, MET, SET,
KFT, MEAS (without
T and T/Flow), CAL
MEAS
.LP.TIM Time for reaching last measuring point in s DET, MET, SET,
KFT, KFC, MEAS,
CAL MEAS
.LP.UGE Potential at generator electrode for last measuring point; 0 = not
defined, 1 = <14 V, 2 = 14...28 V, 3 = >28 V KFC
.LP.VOL Volume for last measuring point in mL DET, MET, SET, KFT
.LP.MEA Measured value for last measuring point in the units of the
measured value
DET, MET, SET,
KFT, KFC, MEAS,
CAL MEAS
.LPO Current absolute lift position in mm (entry at end of command) LIFT
.LST Start time of loop command ( Date/Time ) LOOP, CAL LOOP
.MA.GFL Maximum gas flow in mL/min MEAS T/Flow
.MA.MEA Maximum measured value (U
ind
) in mV MEAS
.MA.MEA Maximum measured value in the units of the measured value DET, MET, SET, KFT
.MA.TEM Temperature for maximum measured value in °C DET, MET, SET,
KFT, MEAS (without
T and T/Flow)
.MA.TIM Time for reaching the maximum measured value in s DET, MET, SET,
KFT, MEAS
.MA.VOL Volume for maximum measured value in mL DET, MET, SET, KFT
.MI.GFL Minimum gas flow in mL/min MEAS T/Flow
.MI.MEA Minimum measured value (U
ind
) in mV MEAS
.MI.MEA Minimum measured value in the units of the measured value DET, MET, SET, KFT
.MI.TEM Temperature for minimum measured value in °C DET, MET, SET,
KFT, MEAS (without
T and T/Flow)