Metrohm tiamo 1.0 Manual - Manual (Page 334)

310 Method
Value
on, [ off ]
-1.0E-99 ... 1.0E+99 (for Type = Number )
100 characters (for Type = Text )
'Date' (for Type = Date/Time )
If this option is enabled, any value can be assigned to the method variable.
The date has to be entered in the calendar window for variables of the type
Date/Time .
Check at start
[ on ], off
If this option is enabled, the start check will check if the method variable is
valid and if the limits are met when monitoring is switched on.
Note
Switching off this option can be useful if the method variable is invalid at the start
of the method because it will be defined in a
REQUEST command during the run.
Comment
1000 characters
Comment about the method variable.
Variable monitoring
on, [ off ]
The limits for the variable will be monitored while the determination is run-
ning if this option is enabled. The monitoring cannott be activated for
method variables of the type Text .
Lower limit
10 numbers (for Type = Number )
'Date' (for Type = Date/Time )
Lower limit for the variable.
Upper limit
10 numbers (for Type = Number )
'Date' (for Type = Date/Time )
Upper limit for the variable.
Message
Text (unlimited)
The message defined here can be put out to different targets if the limits
are exceeded. The Text editor to enter or change the message is opened
with or by double-clicking into the message field.
Display message
[ on ], off
If this option is enabled, all active tracks are halted and the message de-
fined above will be displayed in case the limits are exceeded.
Record message
[ on ], off
If this option is enabled, the message defined above will be documented in
the determination in case the limits are exceeded.
Message by e-mail
on, [ off ]
If this option is enabled, the message defined above will be sent to the ad-
dress defined under
[E-mail] in case the limits are exceeded.
Opening the dialog window Send e-mail for defining the e-mail parameter.