Metrohm tiamo 1.0 Manual - Manual (Page 447)

Commands 423
General/Hardware
Command name
25 characters, [ MEAS Ipol # ]
Name of the command.
The general parameters for the control device, the sensor and the stirrer are de-
fined on this tab.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ Titrando ]
Display or selection of the device type. If a device is selected under Device
name , this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Sensor
Measuring input
[ 1 ] ... 2 (Titrando)
[ 1 ] ... 2, diff. (Titrino)
Selection of the measuring input to which the sensor is connected.
Sensor
Sensor name, [ Metal electrode ], Conductivity sensor
Selection of a sensor from the sensors configured in the sensor table.
I(pol)
-125.0 ... [ 5.0 ] ... 125.0 µA (Titrando, increment = 2.5 µ A)
-127 ... [ 5 ] ... 127 µA (Titrino, increment = 1 µ A)