Metrohm tiamo 1.0 Manual - Manual (Page 260)

236 Database
• Statistically linked determinations
If determinations are selected for reprocessing that are statistically
linked with other determinations that have not been selected then
these determinations will also be automatically reprocessed and then
saved as new versions. Determinations that are statistically linked with
each other must always be reprocessed in the same sequence as
they were recorded. If no modification is made to a determination then
this determination will retain its original determination status (i.e. origi-
nal for non-modified determinations).
• Start test
During the start test all device tests and device monitoring will be ig-
nored.
• Special tracks
During reprocessing the series start, series end and error tracks are
not run through again.
• Tracks with "Return immediately"
If the method contains tracks for which the option Return immediately
has been switched on then a warning will appear to say that it can no
longer be guaranteed that the method will proceed in the same way
during reprocessing as during the determination itself.
• Monitoring
If the method contains monitoring of variables and results then any
messages which may occur will be shown and included in the report,
but no e-mails will be sent nor will beeps be produced. If one of the
two actions
Stop determination or Stop determination and series is
switched on then reprocessing will be canceled.
• Titration and measuring commands
For DET, MET, SET, KFT, KFC, MEAS, CAL MEAS only the evaluations
will be recalculated with the existing data, all other parameters will be
ignored. For commands that generate data, which are carried out dur-
ing the determination but are no longer carried out during reprocess-
ing, all the existing values will be deleted. If commands that generate
data are carried out for the first time during the recalculation then the
recalculation will be terminated.
• Waiting and timeout periods
All waiting and timeout periods in commands will be set to the value 0
for the recalculation.
• Non-executed commands
The commands REPORT, REQUEST, WAIT, RECEIVE, SEND, TRANS-
FER, STIR, SCAN, CTRL, MOVE, SWING, LIFT, PUMP, RACK,
HEATER, FLOW, ADD, LQH, PREP and EMPTY will be performed but
not executed.
• Command variables
If a method contains calculations using command variables the de-
termination can only be recalculated correctly if the DATABASE com-
mand is executed after the corresponding commands.
• Solution variables
If titrants are altered in the method then their associated variables (e.g.
Titer , Slope ) will always (even when at the same time the correspond-
ing variables have been altered under Variables ) be taken from the
Configuration data and updated for the recalculation.
• Assign titer and common variables
If a determination without statistics is recalculated in which a titer or a
common variable has been assigned, then the assignment will only