Metrohm tiamo 1.0 Manual - Manual (Page 643)

Subwindow Devices 619
Stop bit
[ 1 ], 2
Number of stop bits.
Handshake
[ None ], HW, SW
Type of data transmission protocol.
Timeout
1000 ... [ 2000 ] ... 9000 ms
Maximum waiting time for receiving characters. If this time is exceeded the
reception will be stopped.
Terminator for send
\0D, \0D\0A, \0D\0A\0A, \0D\0D\0A, [ 'empty' ]
Final character for transmission in hexadecimal code.
Terminator for receive
\0D, \0D\0A, \0D\0A\0A, \0D\0D\0A, [ 'leer' ]
Final character for reception in hexadecimal code.
Code page
[ Cp437 ], Cp850, Cp851
Code page used for the data transmission.
Tests the connection to the balance. The dialog window Check connection
appears.
Test connection
In order to test the connection to a balance the balance must be selected in the
Device table and then under
Edit, Properties the Properties window for this device
opened. On the tab RS 232 the button [Check connection] must be pressed.
Opens the dialog window Check connection .
If the print key on the connected balance is pressed then the data provided
by the balance will be inserted in the following fields:
Device name
Name of balance.
Sample size
Sample weight.
Sample size unit
Sample weight unit.
ID1
Sample identification ID1.
ID2
Sample identification ID2.