Metrohm tiamo 1.0 Manual - Manual (Page 494)

470 Method
Parameters
The parameters for the command LIFT are configured in the following dialog win-
dow:
• LIFT
LIFT - Properties
Command name
25 characters, [ Lift # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ 814 USB Sample Processor ]
Display or selection of the device type. If a device is selected under Device
name , this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Target
Tower
[ 1 ], 2
Selection of the tower of the Sample Processor for moving to the required
lift position. Both Tower 1 and Tower 2 are always selectable even if the
Sample Processor has got only one tower.
Lift position
0 ... 235 mm, [ Work position ], Shift position, Rinse position, Special position,
Home position
Input the desired lift position in mm or selecting one of the predefined lift
positions Work position, Shift position, Rinse position or Special position . A lift
height of 0 mm corresponds to the Home position where the lift is moved to
the uppermost stop.
Note
Please make sure that none of the lift positions exceeds the maximum stroke
path given in the tower properties of the device.