Metrohm tiamo 1.0 Manual - Manual (Page 289)

Subwindow Curves 265
Curve
Curve color
Color selection, [ pink ]
Selection of the color for the curve line.
Symbol
Symbol selection, [ off ]
Selection of the symbol for showing the measured values. With off the
measuring points will not be shown.
Symbol color
Color selection, [ pink ]
Selection of the color for the measuring point symbol.
Smoothing
on, [ off ]
Switches curve smoothing on/off.
Smoothing factor x axis
[ 0.01] ... 1000
Factor for smoothing on the x axis.
Smoothing factor y axis
[ 0.01] ... 1000
Factor for smoothing on the y axis.
Show with original curve
on, [ off ]
If this option is enabled then the original curve will be shown in addition to
the smoothed curve (dotted line, same color).
y2 Axis
Command type
[ DET ], MET, SET, KFT, KFC, MEAS, MEAS T/Flow
Selection of the command type for which the curve properties are to be de-
fined. The curve properties defined per command type are saved per curve
window and per client.
Note
When the dialog window is opened the particular Command type that will be se-
lected as standard is that which applies for the curve shown in the curve win-
dow.