Metrohm tiamo 1.0 Manual - Manual (Page 43)

Formula editor 19
Identifier Description Commands
.BLV Blank value of the sensor used for the command (for ISE sensors
only) or the blank value calculated during calibration (for CAL
MEAS Conc)
DET U, MET U, SET
U, MEAS U, MEAS
Conc, CAL MEAS
Conc
.BP{#}.DME Difference in measured values for break point # (1...9) MET
.BP{#}.ERC ERC or 1st derivative for break point # (1...9) DET
.BP{#}.MEA Measured value for break point # (1...9) in the units of the meas-
ured value
DET, MET, MEAS
(without T and
T/Flow)
.BP{#}.TEM Temperature for break point # (1...9) in °C DET, MET, MEAS
(without T and
T/Flow)
.BP{#}.TIM Time for breal point # (1...9) in s DET, MET, MEAS
(without T and
T/Flow)
.BP{#}.VOL Volume at break point # (1...9) in mL DET, MET
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 = READY;
invalid (variable not present) = Command has never been
started All
.CBY Command status; 1 = conditioning active, 0 = conditioning
not active SET, KFT, KFC
.COK Command status; 1 = conditioning criterion fulfilled, 0 =
conditioning criterion not fulfilled SET, KFT, KFC
.CONC Concentration of the solution used for the command DET, MET, SET,
KFT, ADD, LQH
.DBL Total duration for processing the command in s DET, MET, SET,
KFT, KFC, MEAS,
CAL MEAS
.DRI Current or last drift for drift correction in µL/min SET, KFT, KFC
.DCS Duration for processing all start conditions in s DET, MET, SET, KFT
.DTI Time for the drift correction (time from start of titration until end of
command) in s
SET, KFT, KFC
.EGF Last measured gas flow (measured value after processing the
command) in mL/min MEAS T/FLow
.EME Final measured value (measured value after processing the
command) in the units of the measured value
DET, MET, SET,
KFT, KFC, MEAS,
CAL MEAS
.ENP Electrode zero point of the sensor used for the command (di-
mensionless for pH sensor or in mV for ISE sensor) or the elec-
trode zero point calculated from the calibration (for CAL LOOP) DET, MET, SET,
KFT, MEAS, CAL
LOOP
.EP{#}.DME Difference in measured values for end point # (1...9) MET
.EP{#}.DVT Drift for end point # (1...9) in µg/min KFC
.EP{#}.ERC ERC for the end point # (1...9) DET
.EP.MEA Measured value for the end point in mV KFC
.EP{#}.MEA Measured value for the end point # (1...9) in the units of the
measured value
DET, MET, SET, KFT