Metrohm tiamo 1.0 Manual - Manual (Page 264)

240 Database
Results with statistics
Result name
Result name
Selection of the statistically evaluated result by using the result name for
which the individual results of all determinations are shown.
Table of individual results
For the result selected above the following data for the individual determi-
nation is shown:
Determination start
Shows the date and time at which the determination was started.
Version
Shows the version number of the determination.
Sample size
Shows the sample size.
Result value
Shows the result value. The statistical data (mean value, standard devia-
tions, etc.) for the selected determination are listed in the subwindow
Result
view .
With this button all the individual results for the selected determination can
be switched on and off for the statistical calculations. If the determination is
switched off then an asterisk (
* ) appears behind all the result values in the
table and the line is shown as inactive (gray); if it is switched on again then
the asterisks will disappear. Updating the statistics data always only takes
place with
[Recalculate] .
With this button all the individual results selected in the table for statistical
calculations can be switched on and off. If the result is switched off then an
asterisk ( * ) appears behind the result value in the table; if it is switched on
again then the asterisk will disappear. Updating the statistics data always
only takes place with
[Recalculate] .
Note
If the results of a determination are switched off then when this determination is
recalculated the statistics for these results will be switched off, i.e. no data for
the mean value and standard deviations will be shown. However, the determina-
tions remain statistically linked to each other so that the results can also be swit-
ched on again.