Metrohm tiamo 1.0 Manual - Manual (Page 353)

Commands 329
Upper limit pH
-20.000 ... [ 20.000 ] (for Window = Measured value )
Value for the upper limit of the window.
Upper limit
0.00000 ... [ 9999.99 ] mL (for Window = Volume )
0 ... [ 999999 ] s (for Window = Time)
Value for the upper limit of the window.
Additional measured values
Command name
25 characters, [ DET pH # ]
Name of the command.
6 further measured values can be defined here at the maximum. These additional
measured values are saved together with the default measured values in the list of
measuring points in additional columns
Calculated # or External # respectively:
Additional calculated measured values
on, [ off ]
3 new measured values can be calculated from existing measured values.
They can be displayed in curves with the identification
Calculated 1...3 or
used as variables 'Command name.CA1...3' in formulae.
Open the dialog window Calc. measured value # (see below) with the pa-
rameters for the additional measured value.
Open the dialog window Calc. measured value # (see below) to edit the pa-
rameters of the additional measured value.
Delete the selected calculated measured value.