Metrohm tiamo 1.0 Manual - Manual (Page 434)

410 Method
5.6.6 Measuring commands
Commands for measurements with different measured quantities.
The following eight measuring commands can be selected:
• MEAS pH
Potentiometric pH measurement with pH electrodes.
• MEAS U
Potentiometric voltage measurement with metal electrodes.
• MEAS Ipol
Voltametric measurement with selectable polarization current (meas-
ured quantity U).
• MEAS Upol
Amperometric measurement with selectable polarization voltage
(measured quantity I).
• MEAS T
Temperature measurement.
• MEAS T/Flow
Temperature and gas flow measurement.
• MEAS Conc
Concentration measurement (direct measurement).
• MEAS Cond
Conductivity measurement.
MEAS pH
Command for potentiometric pH measurements with pH electrodes.
Devices
This command can be executed with the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS pH are configured on the following 4 tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
• Evaluations
Defining further methods for evaluating measurement curves.
• Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.