Metrohm tiamo 1.0 Manual - Manual (Page 266)

242 Database
Edit curve ebvaluation
Edit curve evaluation
The evaluation of the selected curve can be edited manually here.
Command name
Command name
Selection of the measuring command for which the curve is to be shown for
reprocessing.
Toolbar
The toolbar above the curve contains symbols for the following functions for re-
evaluation of the curve:
Set EP manually
By moving the mouse a point on the curve is selected. The current X
and Y values are shown graphically with a blue crosswire and numeri-
cally above the curve. A new end point can be set by clicking with the
left-hand mouse key. This function is activated as standard when the
window Curve evaluation is opened.
Set EP with intersection lines
By moving the mouse a point on the curve is selected to which the tan-
gent is automatically applied. The first tangent is set by clicking with the
left-hand mouse key. The mouse is then used to select a second point
to which the second tangent is to be applied. The tangent is set with a
click with the left hand mouse key and at the same time a new end
point is set at the point where the tangents intersect.
Set EP with parallel tangents
By moving the mouse a point on the curve is selected to which the tan-
gent is automatically applied. At the same time a tangent parallel to it is
applied to the other leg of the curve. The two tangents are set with a
click of the left-hand mouse key and at the same time a new end point
is set at the intersection of the middle lines of the two tangents with the
curve.