Metrohm tiamo 1.0 Manual - Manual (Page 126)

102 Workplace
3.4 Tools
3.4.1 Run test
On the tab Single determination with the or menu item Tools, Run test the Start
test for the method defined under Method can be carried out. A requirement is that
the workplace is in the READY status.
Method
Shows the method for the single determination.
Status display
One of the following status displays appears beneath the line number:
Run test running...
This display appears when the test sequence is running. A progress bar
also appears; the test can be canceled with beside the bar.
Run test error
This display appears when an error occurs during the run test. In a determi-
nation series the user can determine to which line the error message pro-
duced by the error and shown in the normal message window belongs by
using the line number.
Run test stopped manually
This display appears when the run test is canceled manually by the user.
Run test finished without errors
This display appears at the end of an error-free run test.
3.4.2 Sample assignment table
General
With the Sample assignment table you can ensure that samples will always be
automatically processed by the correct method by using sample identifications.
The method that is to be loaded automatically for a particular Assignment ID is de-
fined in the sample assignment table. For this to work the option Method selection
by assignment ID must be switched on in the tab Process of the Properties of the
Single determination or Determination series and one of the sample identifications
ID1...ID8 must have been selected as the assignment ID. As soon as an Assign-
ment ID is recognized during processing sample data for single determinations or
sample data lines for determination series the corresponding method will be
automatically entered in the field
Method . This field can then no longer be edited
and is shown in gray.
Note
The sample assignment table applies for all opened workplaces and is saved
per client.