Metrohm tiamo 1.0 Manual - Manual (Page 446)

422 Method
Lower limit
[ -2'000.0 ] ... 2'000.0 mV (for Window = Measured value )
[ 0 ] ... 999'999 s (for Window = Time )
Measured value for the lower limit of the window.
Upper limit
-2'000.0 ... [ 2'000.0 ] mV (for Window = Measured value )
0 ... [ 999'999] s (for Window = Time )
Measured value for the upper limit of the window.
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MEAS Ipol
Command for voltametric measurements with selectable polarization current.
Devices
This command can be executed with the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Ipol are configured on the following 4
tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
• Evaluations
Defining further methods for evaluating measurement curves.
• Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.