Metrohm tiamo 1.0 Manual - Manual (Page 438)

414 Method
Stop measured value pH
-20.000 ... 20.000, [ off ] (Titrando only)
Stops when the preset measured value has been reached since the start of
the measurement.
off means no stop.
Temperature
Temperature
-20.0 ... [ 25.0 ] ... 150 °C (Titrando)
-170.0 ... [ 25.0 ] ... 500 °C (Titrino)
Manually entered measuring temperature. If a temperature sensor is con-
nected and temperature measurement on the tab General/Hardware is set to
automatic or continuous , the temperature is measured continuously. The
value is used for the temperature adjustment during the measurement.
Evaluations
Command name
25 characters, [ MEAS pH # ]
Name of the command.
The following methods for evaluating measuring curves are defined on this tab.
Fix end point evaluation
on, [ off ]
To a fixed quantity ( Measured value or Time ) the associated values for the
other quantities are interpolated from the list of measuring points for the
fixed end point.
Fixed quantity
[ Measured value ], Time
Selection of the fixed quantity to which the associated values for the other
quantities are to be interpolated from the list of measuring points.
Fix EP# at pH
-20.000 ... 20.000, [ off ]
Fixed end point 1 ... 9 for Fixed quantity = Measured value .