Metrohm tiamo 1.0 Manual - Manual (Page 368)

344 Method
Switch on/off automatically
[ on ], off only Titrino 751, 785, 798, 799)
If this option is enabled, the stirrer will be switched on automatically at the
start of the command and will be switched off automatically at the end of
the command.
Start conditions
Screenshot and parameters: see DET U - Start conditions
Titration parameters
Screenshot and parameters: see DET pH - Titration parameters
Stop conditions
Screenshot and parameters: see DET U - Stop conditions
Potentiometric evaluation
Command name
25 characters, [ DET Ipol # ]
Name of the command.
Parameters for the potentiometric evaluation of the titration curve with automatic
equivalence point recognition. One of the following evaluation methods can be
chosen:
Evaluation without window
Parameters: see DET pH - Potentiometric evaluation
Evaluation with measured value window (Ipol)
Screenshot and parameters: see DET pH - Potentiometric evaluation
Evaluation with volume window (mL)
Screenshot and parameters: see DET pH - Potentiometric evaluation