Metrohm tiamo 1.0 Manual - Manual (Page 389)

Commands 365
defining the conditions which have to be met at the start of the titra-
tion.
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
• Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
• Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
Screenshot and parameters: see DET Ipol - General/Hardware
Start conditions
Screenshot and parameters: see DET Ipol - Start conditions
Titration parameters
Screenshot and parameters: see MET pH - Titration parameters
Stop conditions
Screenshot and parameters: see DET U - Stop conditions
Potentiometric evaluation
Screenshot and parameters: see DET Ipol - Potentiometric evaluation
Additional evaluations
Screenshot and parameters: see DET Ipol - Additional evaluations
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values