Metrohm tiamo 1.0 Manual - Manual (Page 44)

20 General program functions
Identifier Description Commands
.EP{#}.MEP Number of end points in the window # (1...9); 1 = 1 end point,
2 = 2 or more end points
DET, MET, SET, KFT
.EP{#}.QTY Measured value (water) for end point # (1...9) in µg KFC
.EP{#}.TEM Temperature for end point # (1...9) in °C DET, MET. SET, KFT
.EP{#}.TIM Time for reaching end point # (1...9) in s DET, MET, SET,
KFT, KFC
.EP{#}.VOL Volume for end point # (1...9) in mL DET, MET, SET, KFT
.ETE Final temperature (temperature after processing the command)
in °C DET, MET, SET,
KFT, KFC, MEAS
(without T and
T/FLOW), CAL
MEAS
.EVT Final volume (total volume added at the end of the command) in
mL DET, MET, SET, KFT
.FIN Command status; 1 = command has been finished at least
once, 0, invalid (variable not present) = command has never
been finished
All
.FP{#}.DME Difference in measured values for fixed end point # (1...9) MET
.FP{#}.MEA Measured value for fixed end point # (1...9) in mV KFC, MEAS (without
T/Flow)
.FP{#}.MEA Measured value for fixed end point # (1...9) in the units of the
measured value
DET, MET, SET, KFT
.FP{#}.DVT Drift for fixed end point # (1...9) in µg/min KFC
.FP{#}.ERC ERC for fixed end point # (1...9) DET
.FP{#}.QTY Measured value (water) for fixed end point # (1...9) in µg KFC
.FP{#}.TEM Temperature for fixed end point # (1...9) in °C DET, MET, SET,
KFT, MEAS (without
T and T/Flow)
.FP{#}.TIM Time for reaching fixed end point # (1...9) in s DET, MET, SET,
KFT, KFC, MEAS
(without T/Flow)
.FP{#}.VOL Volume for fixed end point # (1...9) in mL DET, MET, SET, KFT
.HP{#}.MEA Measured value for HNP # (1...9) in mV (HNP = half-
neutralization potential)
DET, MET
.HP{#}.TEM Temperature for HNP # (1...9) in °C DET, MET
.HP{#}.TIM Time for reaching HNP # (1...9) in s DET, MET
.HP{#}.VOL Volume for HNP # (1...9) in mL DET, MET
.IGF Initial gas flow (measured value at start of command) in mL/min MEAS T/Flow
.IME Initial measured value (measured value before processing the
start condition) in the units of the measured value DET, MET, SET,
KFT, MEAS, CAL
MEAS
.ITE Initial temperature (temperature before processing the start con-
ditions) in °C
DET, MET, SET,
KFT, MEAS (without
T and T/Flow), CAL
MEAS