Metrohm tiamo 1.0 Manual - Manual (Page 288)

264 Database
y1-axis
Command type
[ DET ], MET, SET, KFT, KFC, MEAS, MEAS T/Flow
Selects the command type for which the curve properties are to be defined.
The curve properties defined per command type are saved per curve win-
dow and per client.
Note
When the dialog window is opened the particular Command type that will be se-
lected as standard is that which applies for the curve shown in the curve win-
dow.
Autoscaling
[ on ], off
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be ed-
ited.
Parameters for the graphical presentation of the curves on the y1 axis (left-hand y
axis).
Quantity
Command-dependent selection
Selection of the quantity to be shown on the y1 axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the y1 axis. With auto the label from the
field Quantity will be used.
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the y1 axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the y1 axis.