Metrohm tiamo 1.0 Manual - Manual (Page 388)

364 Method
Start conditions
Screenshot and parameters: see DET U - Start conditions
Titration parameters
Screenshot and parameters: see MET pH - Titration parameters
Stop conditions
Screenshot and parameters: see DET U - Stop conditions
Potentiometric evaluation
Screenshot and parameters: see DET U - Potentiometric evaluation
Additional evaluations
Screenshot and parameters: see DET U - Additional evaluations
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MET Ipol
Command for Monotonic Equivalence Point Titrations with voltametric meas-
urement with (selectable polarization current).
Devices
This command can be executed with the following devices which have the DET
mode:
Titrino: 702, 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836
Appearance
The command has the following appearance:
Parameters
The parameters for the command MET Ipol are configured in the following 7 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for