Metrohm tiamo 1.0 Manual - Manual (Page 257)

Subwindow Determination overview 233
Note
In the template the Command type is defined for which the overlaying of curves is
possible. Curves from the selected determinations can only be overlaid when
the determination method contains a command with this
Command type (e.g.
DET ).
Command name
Selection of command
Selection of the name of the command whose curves are to be overlaid.
This selection is only necessary if the method contains several commands
of the same
Command type .
Open the dialog window Curve overlay templates .
Graphical presentation
Shows the curves according to the settings of the selected template. The com-
mand type (e.g.
DET pH ) is shown centrally above the graph. At the right of the
curve the legend is shown with the line number in the determination table belong-
ing to the determination.
Open the dialog window Print curves (PDF) in which the contents of the con-
trol card can be shown as a PDF file in the required format.
Portrait
on, [ off ]
If this option is switched on then the overlaying curves will be shown in por-
trait format.
Landscape
[ on ], off
If this option is switched on then the overlaying curves will be shown in
landscape format.
Fit to page width
[ on ], off
If this option is switched on then the printout will be adapted to the page
width.
Comment
1000 characters
Possibility of entering remarks about the overlaying curves which will be
shown together with the overlaying curves.
The view of the overlaying curves is shown in the required format as a PDF
file and opened directly with the Acrobat Reader; it can then be printed out
and/or saved.