Metrohm tiamo 1.0 Manual - Manual (Page 142)

118 Workplace
Interrupt run
Interrupts the run of the determination in a sample series. The button is ac-
tive (dark gray) in the status BUSY (determination is running), COND READY
(conditioning criterion has been fulfilled) and COND BUSY (conditioning is
running). In all other cases the button is inactive (light gray). After pressing
the
[Hold] button the [Cont] button appears in its place.
Continue run
Continues the run of the determination in a sample series. The button is
only present in the status
HOLD (determination interrupted) and COND HOLD
(conditioning interrupted). After pressing the [Cont] button the [Hold] button
appears again.
Interrupt series
With this button the running determination in a sample series will be contin-
ued to its end, but no new determination will be started. The button is pre-
sent in the status BUSY (determination is running). In all other cases the but-
ton is inactive (light gray). After pressing [Pause] the button [Cont] appears
in its place.
Continue series
Starts the next determination in the interrupted sample series. The button is
only present in the status
HOLD (series interrupted). After pressing [Cont]
the [Pause] button appears again in its place.
Status display
On the tab Determination series the current status of the workplace is shown:
Status
READY
Ready for the start of a determination or for conditioning.
BUSY
Determination is running.
HOLD
Determination is interrupted.
PAUSE
Series is interrupted.
COND BUSY
Conditioning is running.
COND READY
Conditioning criterion has been fulfilled.
COND HOLD
Conditioning is interrupted.
ERROR
Error.