Metrohm tiamo 1.0 Manual - Manual (Page 46)

22 General program functions
Identifier Description Commands
.MI.TIM Time for minimum measured value in s DET, MET, SET,
KFT, MEAS
.MI.VOL Volume for minimum measured value in mL DET, MET, SET, KFT
.MTE Temperature measurement with sensor; 1 = on, 0 = off) DET, MET, SET,
KFT, MEAS (without
T and T/Flow), CAL
MEAS
.NMP Number of measuring points in list of measuring points DET, MET, SET,
KFT, KFC, MEAS,
CAL MEAS
.RAN Current absolute shift angle of the rack in ° referred to the axis of
the selected tower (entry at end of command)
MOVE
.RPO Current rack position (entry at end of command); 0 means 'not
defined' MOVE
.SAN Current absolute swing angle of the swing head in ° (entry at end
of command) MOVE, SWING
.SLO Electrode slope of the sensor used for the command (in % for pH
sensor or mV for ISE sensor) or the electrode slope calculated
from the calibration (for CAL LOOP) DET, MET, SET,
KFT, MEAS, CAL
LOOP
.SME Starting measured value (measured value after processing the
start conditions) in the units of the measured value DET, MET, SET,
KFT, KFC
.SPO Current external position (entry at end of command); 0 means
invalid position
SWING
.STE Start temperature (temperature after processing the start condi-
tions) in °C DET, MET, SET,
KFT, KFC
.STY Stop type with which the command has been stopped: 1 =
normal;0 = manual or after error DET, MET, SET,
KFT, KFC, MEAS,
CAL MEAS
.SVA Start volume absolute (volume added in accordance with the
start condition "Start volume") in mL DET, MET, SET, KFT
.SVM Start volume measured value (volume added in accordance with
the start condition "Start measured value") in mL
DET, MET
.SVS Start volume measured value (volume added in accordance with
the start condition "Start slope") in mL DET, MET
.SVT Start volume total (volume added in accordance with all three
start conditions) in mL DET, MET, SET, KFT
.TITER Titer value for the solution used for the command DET, MET, SET,
KFT, ADD, LQH
.TOU Timeout status: 1 = max. delay period elapsed; 0 = max.
delay period not elapsed RECEIVE, TRANS-
FER; SCAN
.VOL Added volume ADD, LQH