Metrohm tiamo 1.0 Manual - Manual (Page 96)

72 General program functions
Move
This is where a move to the desired rack, lift or swing head position can be started
manually.
Rack position
Set rack position.
Current position
Shows the current rack position.
Target position
[ 1 ] ... n (depends on the rack), Special beaker 1...16
Entry or selection of the rack position to be moved to.
Start the move to the target position. After the start the button changes to
[Stop] , the two lower buttons are shown as inactive (gray), and the status
display changes from Ready to Move... .
Move to current rack position – 1.
Move to current rack position + 1.
Lift position
Set the lift position for the selected tower.
Current position
Shows the current lift position in mm.
Target position
[ 0 ] ... 235 mm, Home position, Work position, Shift position (only for normal
beakers and ext. pos.), Rinse position (only for normal beakers and ext.
pos.),