Metrohm tiamo 1.0 Manual - Manual (Page 646)

622 Configuration
This button is only shown with a balance or barcode reader. In order to de-
lete the device from the device list the device must be disconnected.
Settings
Barcode reader ID
Shows the identification of the barcode reader.
Input target
[ Active input field ], Method, ID1...8, Sample size, Sample size unit, Sample po-
sition
Selection of the field into which the output from the barcode reader is to be
entered.
Tests the barcode reader connection. The dialog window Check connection
appears.
Check connection
In order to test the connection to a barcode reader, the device must be selected in
the device table and then under
Edit, Properties the properties window is opened
for this device. On the tab Settings the button [Check connection] must then be
pressed.
Opens the dialog window Check connection .
If a barcode is read in with the barcode reader then the received data will
be inserted in the following fields:
Barcode reader ID
Identifier of the barcode reader.
Data
Read-in data.