Metrohm tiamo 1.0 Manual - Manual (Page 213)

Report templates 189
Autoscaling
[ on ], off
If this option is enabled then all the axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be ed-
ited.
Parameters for the graphical display of the curve on the x axis.
Quantity
Command-dependent selection
Selection of the quantity to be shown on the x axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the x axis. With auto the name from the
Quantity will be used.
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the x axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the x axis.
Curve field - y1 axis
s
X pos.
0.0000 ... (max. page width) mm
x-position within the permitted section.
Y pos.
0.0000 ... (max. page width) mm
y-position within the permitted section.
Width
0.0000 ... (max. page width) mm
Width of curve field.
Height
0.0000 ... (max. page height) mm
Height of curve field.