Metrohm tiamo 1.0 Manual - Manual (Page 489)

Commands 465
5.6.9 Automation commands
Commands for the operation of Sample Processors.
The following eight automation commands can be selected:
• MOVE
Moving to a rack position or an external position.
• SWING
Swinging of the robotic arm (with Swing Head only).
• LIFT
Moving to a lift position.
• PUMP
Switching on/off the connected or built-in pumps.
• STIR
Controlling a connected stirrer.
• RACK
Initialization of the rack attached.
• HEATER
Controlling the oven temperature of the 774 Oven Sample Processor.
• FLOW
Regulation of the gas flow of the 774 Oven Sample Processor.
MOVE
Command for moving to a rack position (sample position or special beaker).
Devices
This command can be executed with the following devices:
Sample Processor: 730, 774, 778, 789, 814, 815
Appearance
The command has the following appearance:
Parameters
The parameters for the command MOVE are configured in the following dialog
window:
• MOVE