Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 835)

Multi-Service IronWare Routing Configuration Guide 807
53-1003033-02
Displaying VRRP and VRRP-E information for IPv6
Displaying detailed information
To display detailed information for IPv6 VRRP or VRRP-E, enter the following command at any level
of the CLI
. Syntax: show ipv6 vrrp
Syntax: show ipv6 vrrp-extended
Displaying statistics
To display IPv6 VRRP or VRRP-E statistics, enter the following command.
Brocade# show ipv6 vrrp statistics
Global IPv6 VRRP statistics
-------------------------------
- received vrrp packets with checksum errors = 0
- received vrrp packets with invalid version number = 0
- received vrrp packets with unknown or inactive vrid = 0
Interface 1/3
----------------
VRID 13
- number of transitions to backup state = 1
- number of transitions to master state = 1
- total number of vrrp packets received = 0
. received backup advertisements = 19
. received packets with zero priority = 0
. received packets with invalid type = 0
. received packets with invalid authentication type = 0
. received packets with authentication type mismatch = 0
. received packets with authentication failures = 0
Brocade(config)# show ipv6 vrrp
Total number of VRRP routers defined: 1
Interface 1/3
----------------
auth-type no authentication
VRID 13 (index 2)
interface 1/3
state master
administrative-status enabled
version v3
mode non-owner(backup)
virtual mac 0000.5e00.0217
priority 100
current priority 100
track-priority 1
hello-interval 1000 ms
backup hello-interval 60000 ms
advertise backup disabled
dead-interval 3000 ms
preempt-mode true
ipv6-address 3013::1
next hello sent in 700 ms
short-path-forwarding disabled