Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 509
Multi-Service IronWare Routing Configuration Guide
481
53-1003033-02
Displaying global IPv6 information
Syntax: show rate-limit protocol
describes the fields from the output of show rate-limit protocol command.
Displaying IPv6 information for Router Advertisement
Options
Run the show ipv6 command to display IPv6 information about the newly configured DNS recursive
server addresses, domain name suffixes, and the corresponding lifetime values on an IPv6 host
network.
TABLE 91
Output from the show rate-limit ipv6 subnet command
Field
Description
Fwd
IPv6 traffic that has been forwarded after the device was started or the
counter was reset due to the rate limit policy.
Drop
IPv6 traffic that has been dropped after the device was started or the
counter was reset due to the rate limit policy.
Re-mark
The number of IPv6 packets whose priority has been remarked as a
result of exceeding the bandwidth available in the CIR bucket for the
specific rate limit policy.
Total
IPv6 traffic that has been carried on the interface after the device was
started or the counter was reset due to the rate limit policy.
TABLE 92
Output from the show rate-limit protocol command
Field
Description
Index
Numeric index of the protocol supported by the device.
In use
Whether the protocol is in use or not (True: In use / False: Not in use)
Protocol
Protocol name (0: arp / 2: IPv6 subnet)
Policy Map
The rate limit policy applied on this protocol.
Brocade# show rate-limit protocol
Index 0
In use TRUE
Protocol 0 (arp)
Policy Map abc
Index 2
In use TRUE
Protocol 2 (ipv6 subnet)
Policy Map abc