Clearing statistics for ipv6 subnet rate limiting, Displaying global ipv6 information, Displaying ipv6 cache information – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 489

Multi-Service IronWare Routing Configuration Guide
461
53-1003033-02
Displaying global IPv6 information
Clearing statistics for IPv6 subnet rate limiting
To clear the rate limit statistics for IPv6 subnet addresses, enter the clear rate-limit ipv6 subnet
command at the configuration level.
Syntax: clear rate-limit ipv6 subnet
Displaying global IPv6 information
You can display output for the following global IPv6 parameters:
•
IPv6 cache.
•
IPv6 interfaces.
•
IPv6 neighbors.
•
IPv6 route table.
•
Local IPv6 routers.
•
IPv6 TCP connections and the status of individual connections.
•
IPv6 traffic statistics.
•
IPv6 session flows
Displaying IPv6 cache information
The IPv6 cache contains an IPv6 host table with indices to the next hop gateway and the interface
on which the route was learned.
To display IPv6 cache information, enter the following command at any CLI level.
Syntax: show ipv6 cache [index-number | ipv6-prefix/prefix-length | ipv6-address | ethernet port|
ve number | tunnel number][vrf vrf-name]
The index-number parameter restricts the display to the entry for the specified index number and
subsequent entries.
The ipv6-prefix/prefix-length parameter restricts the display to the entries for the specified IPv6
prefix. You must specify the ipv6-prefix parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373. You must specify the prefix-length parameter as a decimal
value. A slash mark (/) must follow the ipv6-prefix parameter and precede the prefix-length
parameter.
The ethernet | ve | tunnel parameter restricts the display to the entries for the specified interface.
The ipv6-address parameter restricts the display to the entries for the specified IPv6 address. You
must specify this parameter in hexadecimal using 16-bit values between colons as documented in
RFC 2373.
Brocade# show ipv6 cache
Total number of IPv6 and IPv6 VPN cache entries: 3
IPv6 Address Next Hop Interfac
1 6000:: LOCAL ve 60
2 6000::2 LOCAL ve 60
3 fe80::768e:f8ff:fe2a:6200 LOCAL ve 60