Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 807)

Multi-Service IronWare Routing Configuration Guide 779
53-1003033-02
Overview of VRRP
Brocade#show ip vrrp-extended vrid 1
Interface 1/1
----------------
auth-type md5-authentication
VRID 1 (index 1)
interface 1/1
state master
administrative-status disabled
mode non-owner(backup)
virtual mac aaaa.bbbb.cccc (configured)
priority 100
current priority 100
track-priority 5
hello-interval 1 sec
backup hello-interval 60 sec
slow-start timer (configured) 30 sec
advertise backup disabled
dead-interval 0 ms
preempt-mode true
virtual ip address 10.20.1.100
short-path-forwarding disabled
5. To display IPv6 VRRP virtual MAC address configuration information for VRID 1 (for example),
enter the following command:
Brocade#show ipv6 vrrp vrid 1
Interface 1/1
----------------
auth-type no authentication
VRID 1 (index 1)
interface 1/1
state master
administrative-status enabled
version v3
mode non-owner(backup)
virtual mac dddd.eeee.ffff (configured)
priority 100
current priority 100
track-priority 1
hello-interval 1000 ms
backup hello-interval 60000 ms
advertise backup disabled
dead-interval 3600 ms
preempt-mode true
ipv6 address 10:20:1::100
next hello sent in 400 ms
6. To display IPv6 VRRP-E virtual MAC address configuration information for VRID 1 (for example),
enter the following command:
Brocade#show ipv6 vrrp-extended vrid 1
Interface 1/1
----------------
auth-type md5-authentication
VRID 1 (index 1)