Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 266)

238 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPF information
Originating router-LSAs with maximum metric
Condition: Always Current State: Active
Link Type: PTP STUB TRANSIT
Additional LSAs originated with maximum metric:
LSA Type Metric Value
AS-External 16711680
Type 3 Summary 16711680
Type 4 Summary 16711680
Opaque-TE 4294967295
The 03.5.00 release of the Multi-Service IronWare enhances the show ip ospf command to display
LSAs that have been configured with a maximum metric as described in
“Configuring OSPF router
advertisement” on page 211 as shown above in bold.
Displaying the OSPF area translator status information
Run the show ip ospf area command at the OSPF router level, to display the status of the area
translator.
Syntax: show ip ospf area
Table 36 describes the fields from the output of show ip ospf area command.
TABLE 36 Output display of show ip ospf area command
This field... Displays...
Indx The row number of the entry in the router’s OSPF area table.
Area The area number.
Type The area type, which can be one of the following:
•
nssa
•
normal
•
stub
Cost The area’s cost.
SPFR The SPFR value. Number of times the SPF has run for this area.
ABR The ABR number.
ASBR The ASBR number.
LSA The LSA number.
Chksum (hex) The checksum for the LSA packet. The checksum is based on all the
fields in the packet except the age field. The device uses the checksum
to verify that the packet is not corrupted.
Translator The translator role. The types of translator roles are:
•
Candidate
•
Elected
Brocade (config)# router ospf
Brocade(config-ospf-router)#show ip ospf area
Number of Areas is 3, NSSA area 2
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex) Translator
1 1 nssa 1 56 1 1 10802 153598b6 Candidate
2 0 normal 0 56 0 0 4 0001a1f0 --
3 2 nssa 7 56 0 0 798 018c972d Elected