Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 180

152
Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4 information
Syntax: show route-map map-name
The map-name is the name of the route map.
Syntax: show ip bgp route
In the following example, the continue clause of instance 1 has been changed so that program flow
jumps to instance 5. The resulting BGP4 route only has the weight updated and as-path
prepended. These changes show route-map route name
Syntax: route-map
Syntax: [no] continue instance number
Syntax: show ip bgp route
In this example, a match clause has been added to instance 8. Because the match clause of
instance 8 does not get fired, the search for the next instance continues to the end of the
route-map. The set statements set the weight to 10, prepend 300, prepend 100 to the as-path, set
the community to none, and set the local preference to 70. The results of this route-map traversal
appear in the output of the show ip bgp route command.
Brocade# show route-map test
route-map test permit 1
set weight 10
continue 2
route-map test permit 2
set metric 20
continue 3
route-map test permit 3
set community 10:20
continue 4
route-map test permit 4
set community 30:40
continue 5
route-map test permit 5
set as-path prepend 300
continue 6
Brocade(config-routemap test)# show ip bgp route
Total number of BGP Routes: 1
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH m:NOT-INSTALLED-MULTIPATH
S:SUPPRESSED F:FILTERED s:STALE
Prefix Next Hop Metric LocPrf Weight Status
1 10.8.8.0/24 10.8.8.3 20 100 10 BE
AS_PATH: 300 200