Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 718)

690 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPFv3 information
For example, to display the SPF tree for area 0, enter the following command at any level of the CLI.
Syntax: show ipv6 ospf spf tree area area-id
The tree keyword displays the SPF table.
The area area-id parameter specifies a particular area. You can specify the area-id in the following
formats:
• As an IPv4 address; for example, 192.168.1.1.
• As a numerical value from 0 – 2,147,483,647.
In this sample output, consider the SPF node with the router ID 10.223.223.223 to be the top
(root) of the tree and the local router. Consider all other layers of the tree (10.223.223.223:88 and
10.1.1.1:0) to be destinations in the network. Therefore, traffic destined from router
10.223.223.223 to router 10.1.1.1:0 must first traverse router 10.223.223.223:88.
Displaying OSPFv3 GR Helper mode information
Run the show ipv6 ospf command to display information about the graceful restart helper mode
Brocade# show ipv6 ospf spf tree area 0
SPF tree for Area 0
+- 10.223.223.223 cost 0
+- 10.223.223.223:88 cost 1
+- 10.1.1.1:0 cost 1
Brocade# (config-ospf6-router)#show ipv6 ospf
OSPFv3 Process number 0 with Router ID 0x10010101(10.1.1.1)
Running 0 days 0 hours 18 minutes 21 seconds
Number of AS scoped LSAs is 0
Sum of AS scoped LSAs Checksum is 00000000
External LSA Limit is 250000
Database Overflow Interval is 10
Database Overflow State is NOT OVERFLOWED
Nonstop-routing is ENABLED
Route calculation executed 0 times
Pending outgoing LSA count 0
Authentication key rollover interval 300 seconds
Number of areas in this router is 1
High Priority Message Queue Full count: 0
BFD is disabled
Graceful restart helper is enabled, strict lsa checking enabled