Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 733)

Multi-Service IronWare Routing Configuration Guide 705
53-1003033-02
Commands
Clearing all OSPF counters
You can clear all OSPF counters using the clear ipv6 counts command, as shown in the following.
Brocade# clear ipv6 ospf counts
Syntax: clear ipv6 ospf counts
Clearing OSPF counters for a specified neighbor
You can clear all OSPF counters for a specified neighbor using the clear ipv6 counts neighbor
command, as shown in the following.
Brocade# clear ipv6 ospf counts neighbor 10.10.10.1
Syntax: clear ipv6 ospf counts neighbor nbrid
The nbrid variable specifies the neighbor ID of the OSPF neighbor whose counters you want to
clear.
Clearing OSPF counters for a specified interface
You can clear all OSPF counters for a specified interface using the clear ipv6 counts neighbor
interface command, as shown in the following.
Brocade# clear ipv6 ospf counts interface ethernet 3/1
Syntax: clear ipv6 ospf counts neighbor interface ethernet slot/port| ve port-no | tunnel
tunnel-port [nbrid]
Specify the interface options as shown in the following options.
ethernet slot/port – clears OSPF counters for OSPF neighbors on the specified Ethernet
interface.
ve port-no – clears OSPF counters for OSPF neighbors on the specified virtual interface.
tunnel tunnel-port – clears OSPF counters for OSPF neighbors on the specified tunnel
interface.
Using an nbrid value limits the displayed output to an individual OSPF neighbor attached to the
interface.
Commands
The following commands support the features described in this chapter:
• max-metric router-lsa