Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 426)

398 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Management VRF overview
Syntax: telnet vrf vrf-name IPv4 address | ipv6 IPv6 address
The vrf-name variable specifies the name of the pre-configured VRF.
NOTE
The IPv6 management VRF is not supported on Brocade NetIron CES and Brocade NetIron CER
devices.
RADIUS client
When the management VRF is configured, the RADIUS client will sends RADIUS requests or
receives responses only through the ports belonging to the management VRF and through the
out-of-band management port.
Any change in the management VRF configuration will be immediately effective for the RADIUS
client.
NOTE
The RADIUS source interface configuration command ip radius source-interface must be compatible
with the management VRF configuration. Refer to
“Source interface and management VRF
compatibility” on page 396.
TACACS+ client
When the management VRF is configured, the TACACS+ client establishes connections with
TACACS+ servers only through the ports belonging to the management VRF and the out-of-band
management port.
For the TACACS+ client, any change in the management VRF configuration will not affect the
existing TACACS+ connections and the changes will be applied only to the new TACACS+
connections.
NOTE
The TACACS+ source interface configuration command ip tacacs source-interface must be
compatible with the management VRF configuration. Refer to
“Source interface and management
VRF compatibility” on page 396.
TFTP
When the management VRF is configured, TFTP will send or receive the data and
acknowledgements only through the ports belonging to the management VRF and through the
out-of-band management port.
Any change in the management VRF configuration will be immediately effective for TFTP. You
cannot change in the management VRF configuration while TFTP is in progress.
NOTE
The TFTP source interface configuration command ip tftp source-interface must be compatible with
the management VRF configuration. Refer to
“Source interface and management VRF compatibility”
on page 396.