Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 491

Multi-Service IronWare Routing Configuration Guide
463
53-1003033-02
Displaying global IPv6 information
Displaying IPv6 interface information for a specified interface
To display detailed information for a specific interface, enter a command such as the following at
any CLI level.
This display shows the following information.
Routing
The routing protocols enabled on the interface.
Global Unicast Address
The global unicast address of the interface.
TABLE 80
Detailed IPv6 interface information fields
This field...
Displays...
Interface/line protocol status
The status of interface and line protocol. If you have disabled the
interface with the disable command, the status will be “administratively
down”. Otherwise, the status is either “up” or “down”.
IPv6 status/link-local address
The status of IPv6. The status is either “enabled” or “disabled”.
Displays the link-local address, if one is configured for the interface.
Global unicast address(es)
Displays the global unicast addresses, if one or more are configured for
the interface.
Joined group address(es)
The multicast addresses that a device interface listens for and
recognizes.
MTU
The setting of the maximum transmission unit (MTU) configured for the
IPv6 interface. The MTU is the maximum length an IPv6 packet can have
to be transmitted on the interface. If an IPv6 packet is longer than an
MTU, the host that originated the packet fragments the packet and
transmits its contents in multiple packets that are shorter than the
configured MTU.
TABLE 79
General IPv6 interface information fields (Continued)
This field...
Displays...
Brocade# show ipv6 interface ethernet 3/1
Brcoade# show ipv6 interface ethernet 2/2
Interface Ethernet 2/2 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::768e:f8ff:fe2a:6231 [Preferred]
Global unicast address(es):
180::1 [Preferred], subnet is 180::/64
180:: [Anycast], subnet is 180::/64
Joined group address(es):
ff02::1:ff00:1
ff02::1:ff00:0
ff02::1:ff2a:6231
Port belongs to VRF: default-vrf
MTU is 1500 bytes
ICMP redirects are disabled
ND DAD is enabled, number of DAD attempts: 3
ND reachable time is 30000 Milliseconds
ND advertised reachable time is 0 seconds
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND next router advertisement will be sent in 270 seconds
ND router advertisements live for 1800 seconds
No Inbound Access List Set
No Outbound Access List Set
IPv6 RPF mode: None IPv6 RPF Log: Disabled